**Unified** DFI LanParty UT 790FX-M2R-M2RS / Phenom /Data Base Thread**

[pershoot]

I can barely go above 2100mhz stable, as whenever I insert a HEX code and save/exit it goes loco and a clear-cmos won't even help as the HEX code will go too 00 (1.55v) and when I save/exit after that I need to remove my motherboard battery in order to restore it :P

So yeah, I am stuck at 1.175v

ya thats a tough one, since your locked upward. please load optimised defaults, try lowering your multiplier and ram divider, clock up a bit, lower your HT, and then try again on the NB..

good luck