Quote Originally Posted by gongo View Post
oh, i know what i have to do to get the overclock, i have to pull pin 51 low on the ics932s208, but my soldering iron is too large and clumsy. there's not much room for error since the pin pitch is so small. i'm not sure that a hot air rework station would even work since there are a lot of little components that might get pushed around in the process. i'll be getting a thin tip for my iron in the next little bit (probably next month when i have money to spend again) and then i'll warm the bottom of the board with a hot air blower, and reflow just the pin in question with the iron so i can pull it up with a hobby knife.

i'm determined to get to 2.4ghz on this board. buwahahaha.
Hell guys,

Alot of you might not know me but some old and evil people do.

can you ALL

Please check on your boards and confirm if the clockgen is

ics932s208
or
CK409