Quote Originally Posted by T_Flight View Post
OK Guys, I have an excetional card here. I almost am hesitant to post this because I'm worried you guys may not believe me...I'm gonna warn you now that what I'm about to post is pretty unbelievable, and I cannot believe it myself, but it is real.

I currently have my GTX280 SSC at 750/1625/1250 set on the sliders, and it is folding a GPU2 511 point WU and has not EUE'd thus far. It continues to complete steps. I thought for sure that would EUE, but it didn't. I even fired up Furmark and ran a bench in Furmark at the same time and the VRM's only reached 74C!

I do have one issue though... in EVGA Precision it's only showing 1620 on the shaders and 756 on the GPU... I can set the sliders higher and apply, but it still only shows 1620.

This card really is something special. I have not bumped any voltage at all yet. I'm absolutely stunned.

I'll let you guys know when this WU completes, and then I'm gonna go in and run 3DM06. I cannot run Vantage because I don't have the monitor for it.

Edited: OK, a 5750 completed successfully. Just unbelieveable. This is just incredible. I'll try 3DM in a few minutes.

That's cause the shaders only go up by mulitples of 54. to get higher then 1620, you need to go to 1674

Also, on the VRM temps, you should just forget folding on them to get max temps. Furmark loads the cards so much more, and if you run more then the standard 60,000ms (1 minute), then they will probably keep climbing more and might actually stabilize after a certain time. Furmark resolution makes a difference too.