Originally Posted by
M.I.K.E.Y
My Config:
AI OVERCLOCK TUNER ==================== AUTO
OC FROM CPU LEVEL ==================== CRAZY
OC FROM MEMORY LEVEL UP ============== AUTO
FSB FREQUENCY ======================= AUTO
CPU RATIO SETTING ==================== 8.5
CPU CONFIGURATION
CPU CLOCK SKEW ====================== AUTO
NB CLOCK SKEW ======================= AUTO
FSB STRAP TO NORTH BRIDGE ============= Auto
PCIE FREQUENCY ====================== 100
DRAM FREQUENCY ===================== 1333
DRAM COMAND RATE =================== 1N
DRAM TIMING CONTROL ================= MANUAL
CAS LATENCY ======================== 7
RAS TO CAS DELAY ==================== 7
RAS PRE TIME ======================== 7
RAS ACT TIME ======================= 20
RAS TO RAS DELAY =================== Auto
REF CYCLE TIME ===================== Auto
WRITE RECOVERY TIME ================ Auto
READ TO PRE TIME =================== Auto
READ TO WRITE DELAY S/D ============= Auto
WRITE TO READ DELAY S =============== Auto
WRITE TO READ DELAY D =============== Auto
READ TO READ DELAY S ================ Auto
READ TO READ DELAY D ================ Auto
WRITE TO WRITE DELAY S ============== Auto
WRITE TO WRITE DELAY D ============== Auto
WRITE TO PRE DELAY ================== Auto
READ TO PRE DELAY=================== Auto
PRE TO PRE DELAY==================== Auto
ALL PRE TO ACT DELAY================= Auto
ALL PRE TO REF DELAY================= Auto
DRAM STATIC READ CONTROL =========== DISABLED
DRAM DYNAMIC WRITE CONTROL ========= DISABLED
DRAM SKEW CONTROL ================= Auto
AI CLOCK TWISTER =================== AUTO
AI TRANSACTION BOOSTER ============= Auto
EPU II PHASE CONTROL =============== AUTO
CPU VOLTAGE ====================== Auto
LOAD-LINE CALIBRATION ============== Auto
CPU PLL VOLTAGEM ================== Auto
FSB TERMINATION VOLTAGEM ========== Auto
CPU GTLVREF 0 ===================== AUTO
CPU GTLVRED 1 ===================== AUTO
CPU GTLVRED 2 ===================== AUTO
CPU GTLVRED 3 ===================== AUTO
NB GTLVRED ======================= Auto
NORTH BRIDGE VOLTAGE ============== Auto
DRAM VOLTAGEM ==================== Auto
NB DDRVREF ======================== AUTO
DDR3 CHANNEL A VREF ================ AUTO
DDR3 CHANNEL B VREF ================ AUTO
SOUTH BRIDGE 1.5 VOLTAGE =========== Auto
SOUTH BRIDGE 1.05 VOLTAGE ========== Auto
CPU SPREAD SPRECTRUM ============== DISABLED
PCIE SPREAD SPECTRUM ============== DISABLED
Muth everything on auto because it's the only thing that seems to work :-( When i try to set sommthing manual it even not POST ??
I Use the 1003 BIOS
It is strange because with my e8600 everething was ok but now with the Q9550 It su*** all the way ....
Reply With Quote
Bookmarks