Asus M3A79-T Deluxe

[iocedmyself]

Yes, it's a new feature of C'n'Q 3.0 1V is new lowest voltage for C'n'Q as well.

Actually C&Q 3 has 4 default P-states and goes down to .8v, full features allow users to manually set their own P-states.

minde does 3.6ghz on stock vcore benchable too.. but stability is another story.
i did a vantage run at 3.8ghz@1.475v after that i started prime and it rebooted without a bluescreen or something.
3.6ghz@1.425 wasn´t stable either.. core 2 crapped out after 16mins.
acc does nothing for phenom2 at the moment. u can´t enable it...
if u do, u get no post.

Well, maybe it does nothing for you...but that doesn't mean it does nothing for the series as a whole . Have the 790GX asus board and i was getting the same issue. If i changed the ACC setting from OFF/AUTO/ALL/percore the after saving bios setting it would just be blank screen, and i had to shut the comp off wait for the power LED on the board to go out then next power on would be fine. Someone i know that actually hasAsus M3A79-T Deluxe said ACC works fine as well just best to not enable it with the voltage jacked up high, and apply ACC per core. I've been able to squeeze an extra 450mhz from ACC, but it's trial and error to get it to work sometimes.

Does anyone else have trouble using high multipliers? I might just be being stupid but anything higher than 17.5 doesn't run well on my system.

I've found the same issue on multies 18.5 - 20 when i have mem clock set to 1066 in ganged mode, though 21.5 works fine. Some multi's are flakey on certain boards.