Quote Originally Posted by ScottAllyn View Post
Nice shots Bill. My blocks are still sitting in the box on my desk at work, where they'll probably remain over the weekend.

It looks to me like we could benefit from some fitting spacers to keep the threads from going down too far into the nb/sb block. I actually bought some about a month ago without really having a use for them at the time... now I can put 'em to use!

Did you have any trouble getting the stock cooler/heatpipe kludge off the board?
Scott, stock junk comes right off... very minor tape adhesion.

Warrior, I have NO doubt this product will get the job done...

I will admit I am a NEWB at this... here I was thinking after I pulled the stock cooler stuff off... "Hey, what about the DDR3 Mosfets? They are SO close." Granted being a newbiwe and a rookie I have not read through the thread that have discussed this product through its inception. SO, to read the instructions and set the blocks on the board for a dry run... some Pro must have already been thinking about those MOSFET's.