Gigabyte EX58-UD5/Extreme Discussion Thread

[dinos22]

Tony flash to F4f

use NB speed four times the RAM frequency speed

also your uncore is TOO LOW....bump it up to 1.5v just for initial testing
leave the rest of volts on auto except RAM (1.64v and vcore > whatever you required there)

boot direct to 190/200/210

i run past 1.5v uncore all the time for bencing........my RAM volts are 2.1v usually so dont be shy trying volts as long as uncore is not really low and your vdimm high

if you decide to run higher NB speeds this is usually where uncore and vdimm require a LOT more volts..........

i am only suggesting you start high to check if its the volts just in case

then you can drop them as you keep testing to find the sweet spots for your setup