Been working two days on this case, well not constantly, but just about 8 hours or so. Got the back panel mounted and cut out the hole for the PSU. Adjusted the frame a bit so that the PSU would slide in a bit easier. Got the motherboard slides mounted.
Back panel mounted.
Made a couple of spacers so that the panels won't bend.
PSU-hole masked and measured.
Cut out. Need some sanding.
After some filing and sanding the PSU went in perfectly.
Mounted the slides with some countersunk m4 screws. I actually re designed the case a bit and moved the tray the the left so I will have a 15mm space for routing cables through the middle plate.
Got the upper slider mounted as well.
And the tray sits like so:
Works like a charm.
And a video demonstrating the sliding mechanism.
http://www.youtube.com/watch?v=8Kn8Tnz1IAA
Reply With Quote
Bookmarks