Asus M3A79-T Deluxe

[gOtVoltage]

Hmm, now you say it, the NB vid is also default 1.3V, didnt know it was the real NB-voltage setting. "NB-voltage" is default too which is the 1.1V.

I am currently pretty sure too that my PSU is limiting, I have only 1x4pin attached, I did built the 8-pin my self, but havent tried it yet..The restart-effect clearly could be something to do with power. 12V line is 12.03V so no problem there thought.. :S

Setup is somewhere yes.. not far away.

You need to set NB on CPU to 1.3volts or Higher for proper function of CPU. @ 1.15v even @ stock speed will eventualy cause any Phenom to crash regardless of CPUclocks.

1.3v for NB is how your ram is kept stable too..the NB is your IMC. So if you have lower than stock volts you can cause your ram to Reboot your Pc over time. even if you are using 1.8v Jdec seting for basic 800mhz ram.

[faior]

You need to set NB on CPU to 1.3volts or Higher for proper function of CPU. @ 1.15v even @ stock speed will eventualy cause any Phenom to crash regardless of CPUclocks.

1.3v for NB is how your ram is kept stable too..the NB is your IMC. So if you have lower than stock volts you can cause your ram to Reboot your Pc over time. even if you are using 1.8v Jdec seting for basic 800mhz ram.

Thanks for this, I think I am getting somewhere now

3.1GHz 1.4Vcore, NB 2350@1.4V vid, nb voltage 1.26V, HT1930@1.26V, mem 1140MHz 5-5-5-15-2T@2.2V unganged, 6 hours nearly done for stability test.. I didnt believe it would survive though.

[gOtVoltage]

Thanks for this, I think I am getting somewhere now

3.1GHz 1.4Vcore, NB 2350@1.4V vid, nb voltage 1.26V, HT1930@1.26V, mem 1140MHz 5-5-5-15-2T@2.2V unganged, 6 hours nearly done for stability test.. I didnt believe it would survive though.

Anytime


Update ASUS 79-T using ACC+4 and lowest volts i can use in Bios..

Hope This is Good for Vista32bit @3.52ghz