Quote Originally Posted by MadDias View Post
here are my bios screens:









i ran prime as i typed this... at 1.4875v this time.. and it happened again.

22:01:54 12/05/08,CPU#0 (Core#0),46,34,46,100,3302.11
22:02:04 12/05/08,CPU#0 (Core#0),46,34,47,100,3302.11
22:02:14 12/05/08,CPU#0 (Core#0),31,31,47,100,1651.06
22:02:24 12/05/08,CPU#0 (Core#0),30,30,47,100,1651.06
22:02:34 12/05/08,CPU#0 (Core#0),46,30,47,100,3302.11
22:02:45 12/05/08,CPU#0 (Core#0),46,30,47,100,3302.11

also, why can i only choose 1.6GHz as max HT link?
Well your @ 2000HT and the NB is @ 2000mhz

HT can not be higher than NB.

254x8 = 2000ht

1.6 = 8
1.8 = 9
2.0 = 10

Crashing sounds like the CPU or NB needs more Volts to stay stable..

Is it crashing after the CPU is Loaded and HOT?..

I dont know what your temp is ?

Low volts can crash after using prime ,, as heat builds up CPU will need more volts to keep stable..

Also TOO much Volts it will CRASH SOONER.

If your temps are good try raising the NB only..If it crashes right away its a good indication that you may not be running enuff volts or are too hot.

KEEP the HT @ 1.6 and only change NB from 8 to 9. Make shure your HT is @1.6 and not 1.8 when you change NB,, Run Prime ..If your low on Volts or its heat.. Youll crash quik once the Nb is raised.

If you can prime @ 2280nb then You may need to Raise the CPU volts a little to stabilize the System.

1.45-1.5v NB is good for 2400mhzNB even on stock cooler. I suspect your CPU need volts if anything.

Try the NB @ x9 = 2286mhz ,,
254 x 9 = 2286nb

Make shure HT is 1.6 when you change NB to x9

Try that then post results with TEmps..

Also Use the 602bios the 504 crashes alot ,especially with ACC,, trust me.