DFI Lanparty UT P45-T2RS Banter starts here!!!

[prostoman]

So I got my new set of OCZ Reaper 8500 4GB ram, good thing a guy from DHL dropped of a Vista SP1 64bit DVD right after that, so i can use all 4GBs and not just 3 of them

My previous RAM was at its limit at about 1000MHz, but it looks like so was my board. I am struggling to repeat that fsb500 stunt, but......ah there we go, it crashed 2 minutes after priming at 7x495.

The things I discovered that work for higher FSB on my board are:
IN DRAM TIMING section!
-Set performance LVL (read delay) as low as possible, 14 or 15.
-REF to ACT Delay (tRFC) for my ram at least down to 60.

IN VOLTAGE settings!
SB Core/CPU PLL Voltage at 1.75 (anything higher does not help) + (this voltage bump helps alone with out above mentioned tweaks to at least make Vista boot process start)

Hope this is easy to understand, otherwise ask.

Other than that:
CPU VCore about 1.40-1.42
CPU VTT 1.414
Clockgen voltage 3.60
GTL Values all at 0.63 (works best here)

EDIT: Priming again with same settings but both CPU Clock Scews are set to 500. I googled it and it turnes out the right setting there can give us 10-15% better overclock. The article was a few years old, but 8 minutes and still priming. Coinsidense?