Thank you to all for your advice on safe voltages. I found myself most of the time saying "wow, I am way below that" and on rare occasions saying "ooooops.... "
Well, I promised to put out some screenies of my results I had yesterday, and here they are.


Click image for larger version.  Name: 4754MHz.jpg  Views: 503  Size: 191.2 KB  ID: 89975

CPU-Z screenie shows my max overclock so far, I had about 1.55 on the vcore, remember this was in a cold room. My C0 is so much behind all you guys with E0 quads


Click image for larger version.  Name: SPi 9.953.jpg  Views: 691  Size: 196.5 KB  ID: 89977

My final SPi score was below 10seconds, so I reached the goal I set to my self.

And probably one of the most exciting overclocks of them all, breakthrew in my rather low FSB wall!

Click image for larger version.  Name: 8x500 =4004.jpg  Views: 567  Size: 198.9 KB  ID: 89979

After the room temps have gone up to be comfortable levels and I was about to quit, I tried booting up at fsb 455, and it did. I tried 465, 475, 485, 495 and botted no problem every time. Finally I managed to boot in at 500 as you can see on the screenie, but my memory is not working right and has to go back. It craps the pants anywhere near 1000MHz, so while no problem at fsb 495, I had to slack the timings for 500. I think with better memory (should arrive in a few days ), I wil continue climing the fsb wall.

I left it priming at 10x390 for the night, but the stupid Vista is newly installed and not configured yet, rebooted for some updates (says in the log) and interupted my priming session

Enjoy!