Quote Originally Posted by nugzo View Post
Hi pierreandre. Yes seems to be an issue with resuming from sleep atm with this board. Hopefully fixed soon with bios update. What kind of temps are you getting with Prime 95 Small FFT? I can not pass Linpak either but i can prime 95. Just cos you cant pass linpak that doesnt mean your not stable. Linpak stresses your system way way harder than anything else. If you can pass Prime Small and Blend for 6-8 hours your probably just fine. I do run linpack but if it fails i dont consider my OC a failure. Also according to your ss your GTLs are set at auto. You may want to look back a few pages and follow Electrosadist gtl procedure. Worked great for me. Good luck
Hi Nugzo, thanks for your answer.
I haven't tested Prime95 for that long, I will. The Intel Burn test make my hardware scream. But in a normal use of my computer, games and games actualy, the CPU temp never goes over 75 °c and no errors or BSOD at all.

About the GTLs I've read again and again the Electrosadist post about voltages .. and for me there's no way to set my voltages as Electrosadist ones.. I can't set 0,881 v at all.. the value isn't in the voltage selection panel which is strange because I'm using the same voltages as his. I followed the GTLs Section of this forum and calculate my own values, but again no luck on those settings, only 'Auto' works for now.

I wish that Electrosadist could post a picture of his Bios voltage section.
Can't you post your exact values Nugzo ?

And finally I'm considering buying some new Ram sticks with some great features @ 500 Mhz FSB. BTW which ram kit 2x2 Go would you be best at this freq ? What's your advice ?

Thanks again folks