G.SKILL F2-9600CL5D-4GBPI Sample testing

[Roger_D25]

Guys - You probably read through my post but just incase you didn't I want to be clear. The picture I posted above is not an actual picture of my modules, I just copied that picture from earier in the thread because it was almost exactly the same from what I viewed of my own modules. With that said however its very clear their ProMOS without a doubt, definatly not PSC.

LuckySevn - I've only had my Rampage Formula for about a week now so I'm not sure about this but maybe you could try using "SetFSB" to raise the RAM speed once your booted into Vista (not sure if there is a SetFSB for our board though)? Its been a while since I used that program so I kinda forget if it would even be possible to do that? I'm just about to start watching a movie with the girlfriend (don't have a TV so we use my computer) so I'll have to post some benchies tomorrow afternoon. Fortunatly once I'm done with work I've got the night off for testing and tuning!

-n7- Thanks for confirming my thoughts about the 4GBPI IC's, much apprecaited! I tried searching for more detailed information about the IC's (like you can for Micron chips by going to Micron's website) but didn't have much luck). Not much to learn, I was just curious about the tech information on the chips themselves.

EDIT: I just noticed LuckySevn that your running 8GB of RAM (4 x 2GB), no wonder your having some difficulties booting into Vista at 1200Mhz! Having 4 2GB high-density modules puts alot more stress on the memory controller, I bet you wouldn't have much trouble doing it with only 4GB (that is all I'm running, just a 2x 2GB setup).