Quote Originally Posted by zlojack View Post
Well, I've finally got somewhere. These settings passed one run through Memtest86+ and now I've bumped the FSB to 490 and will run HCI Memtest and see what happens. With 500FSB I get DETDRAM with these settings, so I probably need to tweak something as I get up towards higher bus speeds.

I was so frustrated this afternoon that I put my board and RAM up for sale and started looking for a DDR2 board

I've since taken them off the market... I figure I've got to give this board more of a chance and at least wait until I get proper cooling.
Try this

Bios 0601
Extreme Tweaker
Ai Overclock Tuner: Manual
OC From Memory Level Up: Auto
FSB Frequency: 500
CPU Ratio Setting: 8
CPU Configuration
C1E Support: Disabled
CPU TM Function: Disabled
Max CPUID Value Limit: Disabled
Vanderpool Technology: Disabled
Execute Disable Bit: Enabled
Core Multi-Processing: Enabled

CPU Clock Skew: Auto
NB Clock Skew: Auto
FSB Strap to North Bridge: 333
PCIE Frequency: 100
DRAM Frequency: 2000
DRAM Command Rate: 2N
DRAM Timing Control: Manual
1st Information: 8-8-8-18-5-72-12-6
CAS# Latency: 8
RAS# to CAS# Delay: 8
RAS# Pre Time: 8
RAS# ACT Time: 24
Rest : Auto
DRAM Static Read Control: Auto
DRAM Dynamic Write Control: Auto
DRAM Skew Control :

DRAM CMD Skew on Channel A: Auto
DRAM CLK Skew on DIMM A1: Auto
DRAM CLK Skew on DIMM A2: Auto
DRAM CTL Skew on DIMM A1: Auto
DRAM CTL Skew on DIMM A2: Delay 75
DRAM CMD Skew on Channel B: Auto
DRAM CLK Skew on DIMM B1: Auto
DRAM CLK Skew on DIMM B2: Auto
DRAM CTL Skew on DIMM B1: Auto
DRAM CTL Skew on DIMM B2: Delay 50


Ai Clock Twister: Strong
Ai Transaction Booster: Manual

Common Performance Level: 07
Pull-In of CHA PH1: Disabled
Pull-In of CHA PH2: Disabled
Pull-In of CHA PH3: Disabled
Pull-In of CHB PH1: Disabled
Pull-In of CHB PH2: Disabled
Pull-In of CHB PH3: Disabled

EPU II Phase Control: Auto
CPU Voltage: 1.25
Load-Line Calibration: Disabled
CPU PLL Voltage: 1.5
FSB Termination Voltage: 1.12
CPU GTLVerf (0): +40 ( Deafault is 635.. using 667)
CPU GTLVerf (1): Auto( Default is 667.. is if anybody adds think dudes..)
CPU GTLVerf (2): Auto
CPU GTLVerf (3): Auto
NB GTLVerf: Auto ( Default is 64... DONT NEED TO UP THIS. unless u want to lower the clock twister )
North Bridge Voltage: 1.6 (Didn't write the exact value, Everest says 1.66v)
DRAM Voltage: 2.0
NB DDRVref: Auto
DDR3 ChannelA Vref: Auto ( only had to add this on 4x1gb kit)
DDR3 ChannelB Vref: Auto ( as above )
South Bridge 1.5 Voltage: Auto
South Bridge 1.05 Voltage: 1.11339
CPU Spread Spectrum: Disabled
PCIE Spread Spectrum: Disabled