DFI Lanparty UT P45-T2RS Banter starts here!!!

[C-N]

C-N: I have a DMM could you tell me where I could take a reading of the actual DIMM voltage? Do yo think the VTT and MCH/NB might be overvolting as well?

Look at this post http://www.xtremesystems.org/forums/...35&postcount=1 or use the empty cap pad near the motherboard screw you cant quite fit because the heat pipe from the SB to NB runs over it.

I couldn't really answer for the rest of the voltages as I've not attempted to measure them. I wouldn't be too bothered if the VTT/NB voltage was 0.05v over though.

I've also been testing my Powerchip IC Reapers... using the same 333/800 divider and similar low voltages... so far I've managed 8.5x470 DDR2-1129

That'll be the PC2-8000 kit ?

DFI seems to have found a real sweet spot with the default voltages settings and the 333/800 divider but when you raise CPU vcore to get higher overclocks and then offset it with VTT/NB and GTLs... it becomes much harder to find that nice balance of stability.

And thats why you love it