Approximately 96 feet of MDPC-X Sleeving, many hours of work, and a little bit of love I present to you the fully sleeved Corsair 1000HX.





A quick procedure on how I did each cable.
1. Cut 2 heatshrink lengths 20mm each.
2. Use staple in U shape, hold with pliers, put on outer edges of the pin in socket and push gently until all the way in.
3. Gently pull on wire until it pops out, sometimes this required a bit more force than I expected.
4. Slide on 1 piece of heatshrink
5. Slide the sleeving over the cable and tighten it once about 2 inches from the desired length.
6. Cut sleeving past the end of the connector.
7. Slide the rest of the sleeving into desired position.
8. Slide the heatshrink on.
9. Shink the connector side of the heatshrink so that the heatshrink is just over the first piece of metal on the connector.
10. Let cool.
11. Stretch the sleeving as tight as you can get it.
12. Shrink the opposite end heatshrink.
13. Insert new sleeved cable into connector, pops out the staple.
Repeat per cable. I hope that was detailed enough on what I did.