IRONMODS: New AMD Phemon SuperPi 1MB WR - 19.922s

[TiTON]

1. evap temp? have you found a cold bug yet? your HTT ref clock doesn't seem all that low.
2. nb freq seems unrealistically high. isn't there a bug/hack in reporting the nb speeds? i thought i read that a while back.
3. is it really single channel? if yes, why, is there something to gain by running single channel?

Hey Guys.. i see alot fo questions.. but I believe Biohead asked all of them in a single post.. so i am quoting him, and hoping it answers your questions.

1. Evap temp - PC off = -50c ~ -48c. on idle like -40c.. load @ like -32c. These are not official.. i will get better reading for you guys on my Spi 32mb run.

2. NB freq - It is set to the default of "Auto" in bios, which is 10x. If I manually set it to 9x it would not boot. So i figure.. if it boots at 10x, and not at 9x.. i will let it just be. These are my initial results.. so I am still tweaking And haven't figured out why it didn't boot at 9x.

3. Single Channel - Yes.. it is. I am primiarly focusing on what the CPU can do, and haven't done dual channel. Clocking single channel ram is just easier. I am going double channel next.

I hope i answered everyone questions

Ton

Dang.. forgot to answer the question on the cold bug The answer is yes and no.

One 120w 9950BE hard cold bug at -21c in bios. I am talking about a hard lock. I couldn't do anythin w/ it at all on phase. I used a 140w 9950BE.. didn't seem to cold bug at all on my phase. This particular chip is a 120w 9950BE, and I havne't seen it bug on my phase. Both 120w, the one that bugged and not bugged, are exact same stepping and week. So no way to tell.

I have put as much as 1.7v. but didn't see any improvmeent over 1.575 ~ 1.6v. I am going to try DICE later, once I get everythin dialed in.