i got this board yesterday and ive tried voltages on auto and was able to boot and be stable @533x8 with my e8400 but the volts for pll,vtt were to high for my taste. my question is, ive been trying to get stable @9x470 but the lowest i can get pll,vtt is pll@1.57,vtt@1.42. also my vcore@1.425 w/lcc disabled real load@1.36 and vnb@1.30 seems very stable@4270,but are these volts for vtt,pll ok? after reading about a few of these boards frying and taking out some CPUs with them. on my last board i wasnt able to ron vtt,vnb any higher than 1.11 to 1.20. so these high volt are kind of scary. just need some input and advice. thank you