I'm on the final stages of testing the hole set up and this journey is coming to an end...

After the successful leak test (PA120.3 was leaking thru the bleed hole that came loose from Termochill I had to tighten it firmly) I decided to mount the PSU and start the dreadful cable management!

At first glance it seams impossible to accomplish especially you you have a 80A biffy 1000w single rail PSU.

Lets manage some cables?





* I only used a light spray of pin on the back so it would be easier to attach the cables and close the side panel of course.



How about now?





* Work done! Took me a couple of hours to route this for a perfect fit!
Glue gun FTW!



Case Closed!

* Perfect fit!


What do you guys think?






Now I'm going to conect the Cryo-Z for testing and fire this baby up