EP45-UD3P Benches 3D at 670mhz+ FSB

[Flinch]

Guys, I need some help here.

Did some testing with the UD3P and Q9650 (F5a bios)

I set 1.25 in the bios, then went to PC Health (in the bios) and it shows 1.22(LLC Off)

So I fired up Cpu-z and E.T. and low and behold 1.22

Do I believe what I set, or do I believe the pc health-E.T and Cpu-z read?

I've never had a board show different readings in two areas of the bios.



This is running Prime, I'm down to 1.168



WTF is going on with these voltages? such a large droop with so little volts.

I'll edit later on how bad it is at 4.0

Opinions/thoughts appreciated

Edit:Thanks for your input PPInDaHouse

4.0

1.36 bios---1.31 pc health-Cpu-z-E.T.

1.26 Priming



Does this appear to be poor voltage regulation or just a board that needs to be RMA'd?