Quote Originally Posted by raptor1 View Post
hey Saaya

i 'm glad i could finally get the time to post my settings and share them with everyone here on the foxconn forum

if there is any changes or reccomendations that you see that can be done, please let me know

about the case, the hard drive cage on the top of the case under the top cover can be removed and a power supply installed if one so wishes instead of installing on the bottom

the top cover can be removed and replaced with a special top that can incorporate a radiator and fans for a liquid cooling setup

the hard drive cage with the sata connectors / backplane afaik cannot be removed, but i wouldn't want to as this was the main reason i got the case

Raptor1
i was just worried they might block the gx2? but i guess it fits fine
sounds like a damn nice case... how much was it?

4ghz is nice with 1.35v
2ghz mem is nice with below 1.9v vdimm
nb voltage very low, nice...
pl7 even nice!

thats a very sweet config, nice speeds!
if you want you can push things higher, im sure your cpu, nb, fsb and mem all still have potential to push a few mhz higher.
try pl8, more nb voltage (make sure it stays cool), more vtt and then push up the fsb some more. if your cpu is good you can hit 4.4+ but mem probably wont go much above 2100 with full stability i think... heh, they are 1866 after all

but if the other mem dividers work well for you, then you can try a higher fsb with lower mem speeds and then go for 777...

and keep in mind, some JNL kits dont clock as good with 777, but some clock almost the same with 777 as 888... so another thing you could try is lowering the mem latencies to 777, adjusting the mem timings some more and maybe more vdimm... mhhhh what about PL6, has anybody ever pushed PL6 to 500fsb?