DFI LANparty DK P45-T2RS/T3RS (Intel P45) - News|Info|Results

[DemonEyez]

DemonEyez
Lowering voltage on NB is a good thought. I'm looking forward for results

>

Just did some tests, I loose stability when lowering vNB and keeping those timings tight. Prime/Orthos fails after 4 hours.
So it seems that 1.40v is the minimum voltage required for those tight settings with my board

I'll revert back to looser NB timings and lower NB voltage (1.31v) for 24/7 use. Running with those tight NB timings and Performance Level only differs 300MB/s in Everest Read Bandwith and 3ns in latency.
In my opinion the 0.1v increase needed for that is far too much and not worth it for daily use.

@ DemonEyez : How can u get that kind of temperatures from Chipset ( 34* ) couse i have the same board lets say and with 1.28 NB voltage i get like 50*++.

I run with a Swiftech MCW30 waterblock on it.