Quote Originally Posted by Bullshooter View Post
@Expat GriZ
what are your settings for 500FSB RAM 1:2.
Because my Board doesn´t boot over 410FSB with the 1:2 dividier.
I have the same Config. E8600 and 2x2GB CSX Diablos DDR3 2000.
Here it is as it stands now. Timings are about as tight as I can go and be stable.


Tweaker Menu (Bios version 0601)
Ai Overclock Tuner: Manual
OC From CPU Level Up: Auto
OC From Memory Level Up: Auto
FSB Frequency: 500
CPU Ratio Setting: 10

CPU Clock Skew: Auto
NB Clock Skew Auto
FSB Strap to North Bridge: 400
PCIE Frequency: 100
DRAM Frequency: 2000
DRAM Command Rate: 2N
DRAM Timing Control: manual
1st Information: 9 9 9 24 5 88 8 6
2nd Info: Auto 10 6 5 5 7 5 7
3rd Info: Auto 20 8 1 10 10

DRAM Static Read Control: Enabled ( if I disable either or
DRAM Dynamic Write Control: Enabled both of these, BSD.)

>>DRAM Skew Control
>>DRAM CMD Skew on Channel A: Normal
>>DRAM CLK Skew on DIMM A1: Normal
>>DRAM CLK Skew on DIMM A2: Advance 250 ps
>>DRAM CTL Skew on DIMM A1: Normal
>>DRAM CTL Skew on DIMM A2: Normal
>>DRAM CMD Skew on Channel B: Normall
>>DRAM CLK Skew on DIMM B1: Normal
>>DRAM CLK Skew on DIMM B2: Advance 250 ps
>>DRAM CTL Skew on DIMM B1: Normal
>>DRAM CTL Skew on DIMM B2: Normal
Ai Clock Twister: Moderate
Ai Transaction Booster: Manual Perf Level 7, pull ins disabled
EPU II Phase Control: Auto
CPU Voltage:1.5825
Load-Line Calibration: Disabled
CPU PPL Voltage: 1.67006
FSB Termination Voltage: 1.41816
CPU GTLVerf (0): Auto
CPU GTLVerf (1): Auto
CPU GTLVerf (2): Auto
CPU GTLVerf (3): Auto
NB GTLVerf: Auto
North Bridge Voltage: 1.6437
DRAM Voltage: 2.09406
NB DDRVref: +12.5
DDR3 ChannelA Vref: +50
DDR3 ChannelB Vref: +50
South Bridge 1.5 Voltage: 1.57731
South Bridge 1.05 Voltage: 1.13989
CPU Spread Spectrum: Disabled
PCIE Spread Spectrum: Disabled

I hope this helps. I know it looks goofy & the volts are a little high but its been on now for 2 hours without a hiccup. I've tried to emulate what Zeus and the 2 gb guys are flying at and its just not possible for me. I'm now going to try lower ram timings about 1880 - 1900 because I can do 8 8 8 21 82 and hopefully get PL 6 which should be possible. I also have the CPU on Phase and its hovering @ -45 C Thank you LD!!!!

All the best!!

GriZ