Here's what I've done these last couple of days, the inside components painted to Flat Black, the case skeleton all painted with the 3M Rubberized sound dampening spray paint and some other stuff:




Tools I used to do the holes in the case:

Again very easy to make holes with these, instead of using the Dremel discs cutter that is usually a pain.




Black screws for the case (drives and cards):

The big ones will go for Rads and small screws for drives, cards etc. I love allen type screws!




Case components in Flat Black

I will fit 4 sata drives in that only cage I needed some extra space so I removed the 2nd hard drive case.




Case Before

*credits to jdm003 for this pic




After: here's how it looked after Primer>Paint>3M Paint>Enamel all FlatBlack, and with the holes still unfinished:

It took me 2 days to paint (cold weather) and the rubberized spray is really decent and neat looks a bit like powder coating some times but WAY cheaper




FlatBlackCase with smoothed out holes:





Front (notice that I didn't use the 3M rubber for front and back only on the inside):

The red drawing is where I'm going to hide the pump I also did that little hole on the side to connect the wires to the PSU.




Another close up of the case and the magic 3M Rubberized Undercoat





Still deciding what to install as add-ons on the front (extra 120mm fan? Any suggestions?)





Detail of the mobo wires thru hole and some sleeve done:





Detail II Lian-Li fans that came with the case and more sleeving:



Hope you guys enjoyed these updates now I'm stuck a bit waiting for new stock of the BP ST Transfer Fittings so I can attach to the Reservoir.

Other stuff pending also: uv coolant, some extensions, internal card reader, more insulation material from DD, dialectic grease, etc.

I'm also thinking about using 2 black tubing only for the inlet from Fillport to the Reservoir top and from the outlet to the Drain Valve in the bottom (coming out from the last ATI Radeon) what do you guys think? Will it look decent or should I keep all tubing transparent with blue UV?