Asus P5E3 Premium Wi-fi-AP

[ToyTen]

640 PL9 Very good.

[ToyTen]

Watch out guys, here is what I found when checking the NB/SB contact on a new board...

I had to heat the NB Rad a lot because it was impossible to remove it. Paste is hard as stone when cold...



Once cleaned, i found these references:
Did some of you checked that detail? It could certainly be interesting to compare them Premiums with this.

[funkflix]

Which detail do you mean?

This is my one, cleaned from that crazy stuff a few minutes ago..



My Chipset is close to one year old!

[ToyTen]

Mine should be older than yours ? Am i correct ?

[funkflix]

Sorry, can't see anything on your picture.

[ToyTen]

Sorry, can't see anything on your picture.

you have to click on it

[funkflix]

you have to click on it

Tried to, but i just get a error. Just tell me what is the batch of your chipset.

[ToyTen]

here you go:

NU82X48
SLASF
L747B177
INTEL "M" "C" '07

[funkflix]

here you go:

NU82X48
SLASF
L747B177
INTEL "M" "C" '07

Same week, same year. (Don't know what the three last numbers stand for)

Hope i will get the same results as you!

[ToyTen]

Thank you bro
This mobo isn't tested yet, The one I did my results with, Idon't know yet. Must remove the cooling... This one is a brand new one

I love them Premium boards

[funkflix]

Board works great with the new E0 quads. Not compareable to my MSI P54D3..

[zeuverclok]

http://valid.x86-secret.com/show_oc.php?id=424213

657*6 PL9

[zeuverclok]

http://valid.x86-secret.com/show_oc.php?id=424213

657*6 PL9

[ToyTen]

Nice
And about a Super Pi 32mo, at which maximal fsb do you make it ?

Keep pushing

[jeanjean15]

Board works great with the new E0 quads. Not compareable to my MSI P54D3..

Nice !

Can you post your bios setting : NB voltage , FSB voltage ...etc ...

And which DDR3 model is it ? Ocz 1600 platinum EB ?

[funkflix]

If you have the board too, you can look at my settings best with oc-profile: http://www.gravedigga.de/gravedigga/...ile/ALLDAY.CMO



Great memory oc on this mainboard! Close to my 790i.

Edit: It was some handpicked Mushkin PC14400, other kit are Cellshocks.

[jeanjean15]

If you have the board too, you can look at my settings best with oc-profile: http://www.gravedigga.de/gravedigga/...ile/ALLDAY.CMO



Great memory oc on this mainboard! Close to my 790i.

Edit: It was some handpicked Mushkin PC14400, other kit are Cellshocks.

Ok , thanks .

Waouh , Vnb = 1.73 volt for H24 . You are sure it isn't too much ?

Me , i use Vnb = 1.45 volt with 4 Gb of Corsair PC10666 but of course , my bandwitch is only 8.5 Mb/s .

[funkflix]

I fyou can choose up too 2.25V in bios, i think it will be fine! And my nb is cooled with water. It is really cold.

[ToyTen]

This morning's test, I'm searching for good settings on this new 0605 BIOS:

[JohnnyV]

what?! A new BIOS?
noticed any changes (read: improvements) yet? I'm replacing my Q9450 with a E8600 (Q822A435 batch) because high FSB (for quad) + high RAM clocks just didn't work well.
I found a webshop that had all Q822A435 procs in stock

[ToyTen]

what?! A new BIOS?
noticed any changes (read: improvements) yet? I'm replacing my Q9450 with a E8600 (Q822A435 batch) because high FSB (for quad) + high RAM clocks just didn't work well.
I found a webshop that had all Q822A435 procs in stock

There you go for the new one: http://www.xtremesystems.org/forums/...d.php?t=201035
Thanx to pmp

[Booj]

ooh new BIOS! For me about the only thing they can improve over the great 0505 is if they get the 266 strap working.

*I hope they didn't break anything*

[SoulsCollective]

Personally I'd've like to have seen some more mem dividers, a choice of 1440 or 1800 is a bit meh. Also, doesn't seem to have done anything for the ability of the board to push a Yorkie, although I seem to be able to run with a lower vTT.

[Puttz]

This morning's test, I'm searching for good settings on this new 0605 BIOS

Could you please post link to new bios. I have been waiting a while to get Quadfire working properly & AMD/ATI keep telling me it is a ASUS bios issue.

Thanks!

Toy - Looks like we were writing at the same time - Thanks, will try it out today!!

[ToyTen]

the link is a few posts above