SOLVED: EK FC on HD4870 X2 no POST

[NaeKuh]

Hey Pardner I will look into that. It's clearly the cleanest solution. I am using 3/8ID-1/2OD Feser tubing in this build so once I get all the fittings I'll be set.

I was thinking of using Koolance for compression fittings since they have a larger barb and DD Rotaries since I don't need to advertise the MFR name on every single part I install...unless they pay me.

Hint hint.

ROFL..

sandpaper and scratch it off, or paint it.



The passthough is a 1 fit, meaning it fits directly on the G1/4.

And the cards rotate so installation isnt as bad since your dropping 2 cards in at the same time and there locked like that.

CD Also Quick Discconects on the GPU line. I dont think your client will care about the reduction flow in his gpu line, expecially when he wont see a noticable hit on temps, and will make YOUR life easier when you need to service it.

ps: putting a block on this card has increased my case temps a LOT (its a little messy in there maybe thats the reason but who cares? )

that makes no sense because the full card block should take brunt heat of the card and move it to your radiator. If your case temps went up, that is confusing. Where does your rad exhaust to?