Quote Originally Posted by Razmatazz View Post
Amurtigress, you had inquired about default memory settings. Here are mine.

CAS Latancy: 7
RAS to CAS delay: 7
RAS Pre Time: 7
RAS ACT Time: 20
RAS to RAS Delay: 4
Ref Cycle Time: 60
Write Recovery Time: 10
Read to Pre Time: 5

BTW, I tried increasing the PCI-E frequency by 1 as you had. My system became unstable and I couldn't get into vista at a FSB of 425 MHz. If I leave the PCI-E frequency at 100 MHz, I can do most everything at FSB 425 MHz . I am BurnTest stable but again run into Prime95 errors inside of a minute. I'll try playing again with some settings later this weekend.
Hi,

have you tried setting RAS to RAS delay at 8-10 yet? The 4 and 5 as defaults for this value seem to be ancient and wrong setttings that apply more for DDR2 RAM than DDR3. OCZ for example recommends 10. DDR3 RAMs cannot be that different from each other to seriously require such drastically different tmings....

As for PCI-E at 101, that's a pity. But it appears that the PCI-E Freq. is worth tampering with...I wonder if other values than 101 and 100 can bring stability?