Hi,

I am new to this forum and have been reading through the various threads relating to the Striker II Extreme.

I have been trying to overclock my rig but have not had much success, I first tried these settings;

Code:
Extreme Tweaker 

CPU Level Up = Auto
Memory Level Up = Auto
CPU Multiplier = 10
FSB (QDR) Frequency = 1600 (400)
Mem (DDR) Frequency = 1600 (800)
LDT Frequency = 5x

Memory Timing Section 

P1 = Auto
P2 = Auto
tCL = 9
tRCD = 9
tRP = 9
tRAS = 24
Command Per Clock = 2T
tRRD = Auto
tRC = Auto
tWR = Auto
tWTR = Auto
tFAW = Auto
tRD = Auto
tRTP = Auto
tRFC = 60
tREF = Auto

Over Voltage

CPU Voltage = 1.35v
Loadline Calibration = Enabled
CPU PLL Voltage = 1.6v 
CPU VTT Voltage = 1.3v
Memory Voltage + 1.8v
NB Core Voltage = 1.40v
SB Core Voltage = 1.50
CPU GTL_REF0 Ratio = Auto
CPU GTL_REF1 Ratio = Auto
CPU GTL_REF2 Ratio = Auto 
CPU GTL_REF3 Ratio = Auto
DDR3 CHA1 Ref Voltage = Auto
DDR3 CHA2 Ref Voltage = Auto
DDR3 CHB1 Ref Voltage = Auto
DDR3 CHB2 Ref Voltage = Auto
Upon booting into Windows it bluescreened so I upped the CPU Voltage to 1.4 volts. Again did the same when booting into Windows, I then dropped the multiplier to 9 it got to the logon screen I put in my password and as the Windows loading sound went to play it bluescreened.

I have run Memtest for a few hours and on ever pass it was successful even with the recommended memory timings.

CoreTemp shows the VID as 1.2375v.

Any help would be gratefully received.

Thanks!