Custom Cube Case (Scratch Build)

[zuess]

Nice work. That's a good design and I see you are accomplished with the tools of the trade

Thanks, I've seen a lot of your great building skills.
I might even ask you if I could commission you to build me a custom reservior.

That is awesome. Great idea for cutting the 120mm holes. I used something similiar with my dremel to cut 120mm holes in acrylic. Build is coming along nicely, any idea what your material costs were?
Thanks,
Utnorris

Thanks for your comments.
Sure, as far as my costs are, 32' of 1"x1"x 1/16" angle at $3.50' +14% tax
cost me $128.00

4 sheets at 24"x20"x1/16" aluminum I got for $115.00
3 sheets at 20"x20"x1/16" aluminum I got for $80.00

Although I have my own woodworking shop in a garage I still had to buy
some files i didn't have and quite a bit of wet/dry sandpaper as well as three
2"wide rolls of masking tape at $5.00 a roll.
All the stainless steel cap screws and pozi-loc nuts had to set me back at lease $35 to $40.00.