Quote Originally Posted by Eddie3dfx View Post
That looks gorgeous and looks like it takes much less space. I like it as is.
Are you running it at 24v? If so, can we see the results at 12v.

Maybe 2 holes on the bottom and 2 drilled holes on the sides.. No need to bling it up.. looks gorgeous
These are 12V results, I should have labeled that.

Running either the stock Laing housing or this housing, I notice a lot of high frequency vibration, probably 1st order of the impeller speed being transmitted to the table. I've noticed that EK and Koolance just use tapped holes, but Swiftech supplies a gel pad to mount the housing My assumption has been that hard mounting the pump to the case may create other little BSR (I'm an automotive engineer, and BSR is a standard term, means buzz, squeak, rattle).

Perhaps two versions? A cheaper tapped hole version, and a more expensive version that has some isolation?