Quote Originally Posted by iandh View Post
Thanks for posting those results. I'm hoping that we can get some more and get an average for what these run.

Just FYI ceramique is my TIM of choice for mounting. It isn't too thick so you can get good contact with little pressure.

You have to be careful when mounting these, there really isn't too much of a way around it unless I supplied a backplate... which would probably need to be laser cut with a ventilated hole pattern or risk hurting more than helping with temps.

What do you have as far as airflow over the card goes?

Yeah, I'm using ceramique as well. As for air flow, I'm using a MM U2-UFO case with a Thermochill PA120.3 with 3 120mm Yate Loon D12SM-12 pushing air through the rad & 2 pulling air on the middle and bottom of the rad. The fan in the middle of the rad allows air to flow over the top of the card, while the bottom fans allows air to flow over the bottom (where the sinks are).

BTW, is there a program to monitor the temp of the memory on the card? I want to make sure I have good contact all around the ram. When I was putting the sink on the ram, I had a good look to see if light was getting through between the sinks and ram. So I believe have a made good contact, but I just want to make sure.