Micron D9 and high voltage, electromigration effects

[zsamz_]

i damaged my best set goin 1300+

[mad_skills]

Wasn't 1240MHz enough?

[zsamz_]

Wasn't 1240MHz enough?

no are you serious
i wanted to break 12000mb/s
but i got 2 more sets of ballistix 8500 so i'll try again
i guess 2.45 for 10 min was too long lol
i shoulda put in my d9gkx

[CryptiK]

After some arduous hours testing and fiddling, I have found my ram has not degraded. It was my cpu not being stable and causing the crashes, and some of the secondary timings when left on auto were too tight for high MHz stability. I am 20 passes of linpack (Intel Burn Test) stable now @ specs in sig.

I actually booted at DDR1333 Mhz at 2.24v (nowhere near stable obviously) so my sticks can do high freq very well it seems, my board just has a massive hole between 1199 and 1277 MHz where it refuses to boot.

[mad_skills]

no are you serious
i wanted to break 12000mb/s
but i got 2 more sets of ballistix 8500 so i'll try again
i guess 2.45 for 10 min was too long lol
i shoulda put in my d9gkx

Of course i'm not serious.
Be sure to put some active cooling while benching at that voltage.
But that is kinda low (high) voltage. My Team's benched like half an hour on 2.75V with a 120mm fan and didn't degrade.

[zsamz_]

Of course i'm not serious.
Be sure to put some active cooling while benching at that voltage.
But that is kinda low (high) voltage. My Team's benched like half an hour on 2.75V with a 120mm fan and didn't degrade.

i had 2 90mm fans on em lol they never got above 25c

[garson]

My Team's benched like half an hour on 2.75V with a 120mm fan and didn't degrade.

I tought one of your Team is dead.

[mad_skills]

I kinda nursed it back to life.
But i just keep them safe now, don't bench with them anymore.

[zsamz_]

i just retested my stickx they are back
but i need 2.05v for 1220mhz

well i had to punish my d9gkx they still rock solid