**Official DFI LanParty UT X48-T2R(and LT) Discussion

[Justintoxicated]

DAMN thats a good pic of the proc! i have a EOS 40d and i have tried to take some pics like that but no avail..

The IS built into the camera helped I think and the Macro lense is pretty sweet too.

So which is the safe way to run this CPu under water?

Stable clocks for C1 core (Using Intel CPU Burn) are as follows:

3400mhz 1.36v FSB 425 NB 1.5v Vtt 1.40x GTL 1/2-120 0/3-110 NB-130
3500mhz 1.39v FSB 438 NB 1.5v Vtt 1.463 GTL 1/2-125 0/3-115 NB-135
3600mhz 1.39v FSB 450 NB 1.5v Vtt 1.503 GTL 1/2-130 0/3-120 NB-140

Also I'm noticing some multiplier flux @ 3500 mhz it changes between 6 and 8 constantly drasticaly changing the clock speed. Under load it seems to stay at 3500 though? What can I do to fix this? And which of the above values are safe if any?

The 67% rule does not seem to work for this chip, although I have not actualy taken any measurements yet with the DMM so technicaly it could be possible using the charts I either fail to boot or get hard locks/BS while running Intel CPU Burn, Voltages above are what I am setting the values to in the bios. @ 3500 I'm hitting 48Gflops.


Thanks for everyones help so far and in advance as well.