"ASUS P5Q Deluxe discussion".

[Leeghoofd]

When flashing between 1103 and 1201, has anyone experienced the settings you left set in the previous version still being there after the flash and reboot?

Before I flash, I set default cpu speed, set ram to DDR800, set vcore to 1.3625, PLL 1.52v, vFSB 1.12v, vNB 1.20v, vdimm 1.98v, set stock multiplier and ram timings, and set PL = 10, then flash to the new bios. I believe it is more guaranteed to be stable than leaving everything on auto. Before today upon entering into the bios after a flash for the first time, everything has been back to 'AUTO' as you would expect. However when going from 1201 to 1103, then from 1103 back to 1201 again, all those settings remained set in the bios. Nothing was changed from the way I had left it set manually prior to the flash.

Has anyone experienced this?

Before I flash anything I just set all to default and just leave the ram voltage at it's required level... then I flash, and once bios pops up again I reset all again to default but the ram voltage...

chispy has done some voltage readings too... NB value is a tad lower and his rams undervolt big time...I'm getting lost in the dark now lol... on my board nothing has changed (since 0901), on yours it's different and on chispy's it's again different

Asus P5Q-Deluxe / Voltage Readings / Bios 1201

V.Dim - Bios 2.02 , idle 1.96 = v.Dif 0.06 / Load 1.93
V.Dim - Bios 2.10 , idle 2.03 = v.Dif 0.07 / Load 2.01

V.North - Bios Auto 1.12 ,
V.North - Bios 1.10 , 1.08v. dmm = V.Dif 0.02
V.North - Bios 1.20 , 1.17v. dmm = V.Dif 0.03


Link to his test : http://i4memory.com/94959-post85.html