I could use some help here on overclocking my new E8400 on the P5E3-Premium mobo.

As far as I understand VID is the standard voltage the chip will run on when at standard speed. I guess my chip's VID was 1.18V @ 3Ghz (Q817A240; pack date 4-6-2008).

I already searched the internet for some basic settings to start from. The following settings got me into Vista64 but when I start orthos it already gives errors after app. 10 seconds. Would pls take a look at my current settings and give some advise:

CPU ratio: 9.0
FSB: 450
FSB strap: 400
PCI-E: 100
DRAM freq.: 1800
Timings: 8-7-7-25-2T @ 1.98V (factory specs are 7-6-6-24-1T @ 1.9V)
CPU volt: 1.425V
FSB temination: 1.3V
NB volt: 1.45V
Temps. idle: 42 and 36 (measured with speedfan v4.34)

Everything else is on auto including, load line calibration, CPU spread spectrum and CPU PLL voltage.

In my opinion these settings are way to high as compared to other E8400 users here on the board. However lowering one of these settings results in BSOD or no POST. Thanks in advance for the advise which is much appreciated!!!!