**Official DFI LanParty UT X48-T2R(and LT) Discussion

[zsamz_]

^^^ nope didnt help man. went to the bios you said i can boot into windows at 500 @ 8,5 but fails orthos instantly. problem imo is if i set the cpu vid to 1.21x it boot right up... if i set it to even 1.225 or higher fails to boot and i get c1 and no boot... now i can set the northbridge as high it seems as i want i had it set to 1.40 when i booted into windows. didnt go any higher on it though because i think the cpu needs more voltage and i cant seem to give it more. i tried setting the gtl's to the recc range by many member here of 59-65 didnt help..

question i have.. why is my add vid blocked out? i cant select any add vid at all they are all red in the choices menu and if i pick one it just defaults back to auto. i can not even disable that feature it just quickly snaps back to enabled... could this be my issue?? how do i enable this to select a add vid option? it seems i can only even attempt to select them if i set the cpu vid to 1.2 if i leave it on auto or anything below 1.2 the cursor skips right over the option??

so can this possible be another bad mobo or cpu again?? im using a totally different psu and tried one stick and 2 sticks of ram tried some regular samsung sticks i had took one video card out of the crossfire setup.. disabled the jmicron and just about everything else onboard i could nothing seems to help.. at least this e8500 boots up and will pass orthos at stock speeds the last one would not pass any test even at stock speeds on this mobo

you try add 105%+
you plug in them floppy connectors on mobo
you must have another board lyin around to test if not i suggest you buy a cheap p45 biostar