arghhhh this mobo is driving me nuts.. i can go into the bios and set everything for a nice 4.012 oc on my e8500 exit and save boot to windows and passs orthis, prime etc.. runs perfect. if i shut the damn thing down and start cold it simply doesnt boot and throws a c1 error i have to reset the bios and start over then exit and save ... right into windows (im typing from it now with the 4.012 oc just fine with orthos running etc) but i shut it down will not re-start.. what the heck is going on there???
also the e8500 is set at 1.218v in the bios at 422fsb 9.5 multi.. if i go even 1 step higher with cpu voltage will not restart.. same goes for the nb right now its at 1.30 (was required at least here for orthos to be stable for some reason anything lower it was unstable) same thing if i go one step higher .. no boot / c1 i have to clear cmos and start over.. sb is at default and if i step that any higher at all no boot again.. ram is at 2.12 (since it was undervolting just a bit i used 2.12 to get closest to the recc 2.1v) timings on the ram are 5-5-5-15-52 pl 8....right now i tried gtl's at default would not pass orthos im trying them at 62 right now passes fine..ram strap is 333-800 right now same thing there anything else (even lower or higher) no boot
what should i be looking at am i missing anything?? bios is the newest released one from a week or two ago
someone help.. argghhhhhh this overclock shown runs perfect and passes everything but it refuses to boot unless im exiting the bios then its fine
Reply With Quote
Bookmarks