Here is the picts!!!

-SB, you can see that it is not nice too (tim was changed):

->Need to put some thin plastic ring

-NB, really bad contact:

->In order to avoid some more pressure on it, I use that thing:

->M3 Screw+thin ring:

->You also need the smallest cuttin'disk:

->The bottom of the WB doesn't fit, you need to cut the red mark:

->5 minutes later, here it is:


->TEST:

Perfect

Temp' are really better: 35° on both NB (1.32v)/SB


Little bonus:

EK Mosfet X38a fit on MF2

Hope this will help you guys.
Don't forget to use some thin ring under the board, screws are too short. And you can also use some thermal pad (about +/-1mm) to avoid crushing the NB'core.