AI Overclock tuner: Manual
CPU Ratio Setting: 9
FSB Strap to North Bridge: Auto
FSB Frequency: 450
PCI-E Frequency: 101
DRAM Frequency: 1081Mhz
DRAM Timing Control: Manual

1st Information :

CAS# Latency: 5
DRAM RAS# to CAS# Delay: 5
DRAM RAS# Precharge: 5
DRAM RAS# Activate to Precharge: 15
RAS# to RAS# Delay : 5
Row Refresh Cycle Time: 55
Write Recovery Time: AUTO
Read to Precharge Time: AUTO

2nd Information :

3rd Information :

DRAM Static Read Control: Disabled
DRAM Read Training: Disabled
MEM. OC Charger: Disabled
AI Clock Twister: Lighter
AI Transaction Booster: Manual
Common Performance Level [10]

CPU Voltage: 1.34375
CPU GTL Voltage Reference: AUTO
CPU PLL Voltage: 1.52
FSB Termination Voltage: 1.22
DRAM Voltage: 2.12
NB Voltage: 1.22
SBridge Voltage: Auto
PCIE SATA Voltage: Auto

Load Line Calibration: Enabled
CPU Spread Spectrum: Disabled
PCIE Spread Spectrum: Disabled
CPU Clock Skew : Auto
NB Clock Skew : Auto


Been taking your advice in this thread and here is where I am right now. P5Q-Pro 0901 Bios, E8400

9X450 100% Stable RAM is at 5/4 540MHZ

Whenever I drop ratio to 7-8 and set RAM to 500MHZ and try 1/1 I get errors in Windows.

Should I be happy with 4050mhz running 5/4 DDR2-1081 and just try to start working on memory timings or should I try to get the higher FSB?

Im not sure what higher FSB will get for me if RAM is already running 1081mhz at decent settings.

I am REALLY happy with my overclock so far.