Hi all. Needed a new system and ended up going with the 9450 and P5Q. My new gear is below. I'd like to offer a special thanks to those who've gone before me here... cob, luci5r...

JumperFree Configuration Settings
AI Overclock tuner: MANUAL
CPU Ratio Setting: 8
FSB Frequency: 475
PCI-E Frequency: 101
FSB Strap to North Bridge: AUTO
DRAM Frequency: 951
DRAM CLK Skew on Channel A1: AUTO
DRAM CLK Skew on Channel A2: AUTO
DRAM CLK Skew on Channel B1: AUTO
DRAM CLK Skew on Channel B2: AUTO
DRAM Timing Control: MANUAL

1st Information
CAS# Latency: 5
DRAM RAS# to CAS# Delay: 5
DRAM RAS# Precharge: 5
DRAM RAS# Activate to Precharge: 18
RAS# to RAS# Delay : AUTO
Row Refresh Cycle Time: 55
Write Recovery Time: AUTO
Read to Precharge Time: AUTO

2nd Information
READ to WRITE Delay (S/D): AUTO
Write to Read Delay (S): AUTO
WRITE to READ Delay (D): AUTO
READ to READ Delay (S): AUTO
READ to READ Delay (D): AUTO
WRITE to WRITE Delay (S): AUTO
WRITE to WRITE Delay (D): AUTO

3rd Information
WRITE to PRE Delay: AUTO
READ to PRE Delay: AUTO
PRE to PRE Delay: AUTO
ALL PRE to ACT Delay: AUTO
ALL PRE to REF Delay: AUTO
DRAM Static Read Control: DISABLED
DRAM Read Training: AUTO
MEM. OC Charger: AUTO
AI Clock Twister: AUTO
AI Transaction Booster: AUTO
Common Performance Level: AUTO
Pull-In of CHA PH1:
Pull-In of CHA PH2:
Pull-In of CHA PH3:
Pull-In of CHA PH4:
Pull-In of CHB PH1:
Pull-In of CHB PH2:
Pull-In of CHB PH3:
Pull-In of CHB PH4:

CPU Voltage: 1.33125
CPU GTL Voltage Reference (0/2): .635
CPU GTL Voltage Reference (1/3): .675
CPU PLL Voltage: 1.54
FSB Termination Voltage: 1.34
DRAM Voltage: 2.06
NB Voltage: 1.30
NB GTL Reference: AUTO
SBridge Voltage: 1.2
PCIE SATA Voltage: AUTO

Load Line Calibration: ENABLED
CPU Spread Spectrum: DISABLED
PCIE Spread Spectrum: DISABLED
CPU Clock Skew : AUTO
NB Clock Skew : AUTO

Advance CPU Settings:
CPU Ratio Setting:8.0
C1E Suppport: DISABLED
Max CPUID Value Limit: DISABLED
IntelŽ Virtualization Tech: DISABLED
CPU TM Function: DISABLED
Execute Disable Bit: DISABLED

3.8 Ghz
Prime stable at least 8 hours... but
even at only 1.33v, I'm hitting mid 70s on all cores with my TRUE...

Does this sound like a remount is needed or a hot chip?