Still getting issues, not sure whats going on.

I went back to the basics.

E8400, P5Q Pro. 9 X 333 defaults works fine. I raised FSB to 400 and dropped multiplier to 7.

Ram is DDR2800 http://www.newegg.com/Product/Produc...82E16820145184

I get errors in Test 5 of Memtest. Only test 5. Ive tried changing between slots 1/3 and 2/4. RAM is rated for 1.9v and Im running at 2.0. All settings are according to RAM specs.

Does this look like a bad stick of RAM or should I keep tossing more voltage at it? I'm going to try the 0901 Bios and see if it makes a difference.


Bios 0703 :

AI Overclock tuner: Manual
CPU Ratio Setting: 7
FSB Strap to North Bridge: AUTO
FSB Frequency: 400
PCI-E Frequency: 100
DRAM Frequency: 800
DRAM CLK Skew on Channel A1: AUTO
DRAM CLK Skew on Channel A2: AUTO
DRAM CLK Skew on Channel B1: AUTO
DRAM CLK Skew on Channel B2: AUTO
DRAM Timing Control: Manual

1st Information:
CAS# Latency: 5
DRAM RAS# to CAS# Delay: 5
DRAM RAS# Precharge: 5
DRAM RAS# Activate to Precharge: 18
RAS# to RAS# Delay : AUTO
Row Refresh Cycle Time: 50
Write Recovery Time: AUTO
Read to Precharge Time: AUTO

2nd Information :
READ to WRITE Delay (S/D): AUTO
Write to Read Delay (S): AUTO
WRITE to READ Delay (D): AUTO
READ to READ Delay (S): AUTO
READ to READ Delay (D): AUTO
WRITE to WRITE Delay (S): AUTO
WRITE to WRITE Delay (D): AUTO

3rd Information :
WRITE to PRE Delay: AUTO
READ to PRE Delay: AUTO
PRE to PRE Delay: AUTO
ALL PRE to ACT Delay: AUTO
ALL PRE to REF Delay: AUTO

DRAM Static Read Control: Disabled
DRAM Read Training: Disabled
MEM. OC Charger: Enabled
AI Clock Twister: Lighter
AI Transaction Booster: Manual
Common Performance Level: 12
All Pull-Ins: Disabled

CPU Voltage: 1.2675
CPU GTL Voltage Reference : AUTO
CPU PLL Voltage: 1.50
FSB Termination Voltage: 1.20
DRAM Voltage: 2.0
NB Voltage: 1.20
NB GTL Reference: AUTO
SBridge Voltage: AUTO
PCIE SATA Voltage: AUTO