Official Gigabyte X48/X48T-DQ6 bios+info thread

[jaggerwild]

Hello guys, how are you doing?
I hope you can help me.

I'm running the X48-DQ6 with a E7200 and 2x1GB GSkill DDR2-1066.

Settings:
7x500
RAM 2.4B = DDR2-1200 5-5-5-15
tRD 7
vDDR +0.55v
vPCIe +0.2v
vFSB +0.2v
vMCH +0.25v
vCore 1.30v



I can run a full 1024k self test of Prime Blend (10 iterations), but the system will hang/crash short after I start any 3d application.
Note the +0.2v on the PCIe, without it the system will reboot short after the start of the Prime in Blend mode.

Any ideas on how to get the system 3d stable ?

Hey Doompc,

Plus .55 on the DDR? Seems high to me, I have the same MEM DDR2 G-skill 1066 but four sticks. I never volt them that high but do see your over clocking them also, I usually use +.35 or +.40 at the most. But I've not over clocked them on this board yet. If this helps you then cool if not then disregard.....

Got a new bios from Gigabyte (as a response from tech support) - F6D and it seems to have settled the latency issues right down. As noted before there were major stutter with RAID enabled, but even without latency was not quite low enough (up to 1000us sometimes).

Hello Soupratt!
And Welcome!
If you could post a link for that bios or more info on where it is located/came from? Also if you would post full spec's of your system so as to be of more help to you........

I just wanted to see what you guys are running in your settings for your bios. If you have a minute I would like to compare.

Hey Knightstar!
Give me a few days to look up my info on this if you will?

I installed a baby Q9300, the F7b bios did not recognize it. And in the device manager it showed it as unknown item? Under the CPU it showed nothing, very weird. Not sure if there is a patch or what for it? Also in my bios now, it only show dual bios not quad bios? Any help there is always greatly appreciated!!!
Happy Fourth Of July All !