Quote Originally Posted by Leeghoofd View Post
Try these settings Ricochet, plz change one value at a time plz some boards are picky with voltages... so you have an idea where it goes wrong if it didn't post



Try these :

JumperFree Configuration Settings
AI Overclock tuner: MANUAL
CPU Ratio Setting: set 8x first then 9X
FSB Strap to North Bridge: AUTO
FSB Frequency: 450
PCI-E Frequency: 101
DRAM Frequency: 1081
DRAM CLK Skew on Channel A1: AUTO
DRAM CLK Skew on Channel A2: AUTO
DRAM CLK Skew on Channel B1: AUTO
DRAM CLK Skew on Channel B2: AUTO
DRAM Timing Control: AUTO

1st Information :

CAS# Latency: 5
DRAM RAS# to CAS# Delay: 5
DRAM RAS# Precharge: 5
DRAM RAS# Activate to Precharge: 18
RAS# to RAS# Delay : AUTO
Row Refresh Cycle Time: 55
Write Recovery Time: AUTO
Read to Precharge Time: AUTO


DRAM Static Read Control: Disabled
DRAM Read Training: AUTO
MEM. OC Charger: AUTO
AI Clock Twister: AUTO
AI Transaction Booster: AUTO

CPU Voltage: 1.35 --> depending on ya CPU ofcourse
CPU GTL Voltage Reference (0/2): AUTO
CPU GTL Voltage Reference (1/3): AUTO
CPU PLL Voltage: 1.6 --> set first at AUTO then this value, try to find the lowest possible plz
FSB Termination Voltage: 1.32 --> set first at AUTO then this value, try to find the lowest possible plz
DRAM Voltage: 2.1
NB Voltage: 1.26 --> set first at AUTO then this value, try to find the lowest possible plz
NB GTL Reference: AUTO
SBridge Voltage: AUTO
PCIE SATA Voltage: AUTO

Load Line Calibration: Disabled
CPU Spread Spectrum: Disabled
PCIE Spread Spectrum: Disabled
CPU Clock Skew : AUTO
NB Clock Skew : AUTO

Advance CPU Settings
CPU Ratio Setting: Manual
C1E Suppport: Disabled
Max CPUID Value Limit: Disabled
Intel® Virtualization Tech: Disabled
Vanderpool Technology: Disabled
CPU TM Function: Disabled
Execute Disable Bit: Disabled
Ok I think I understand the second grouping now; however, can't my 4gb dominators take 1066 @ 5-5-5-15 timings with a 2.1dimmv? If I had it at 450FSB wouldn't they only be at 900mhz? Also I noticed you thought to loosen the timing to 5-5-5-18, why is this? Also what is the DRAM frequency and PCI-E frequency?

I heard all this talk about a 1:1 ratio, but doesn't it get forced somehow or am I completely lost? I don't want to push my system really hard, but I do want to try to get more performance--hell I don't even know how to clear the CMOS.

More importantly I tried to do Asus instALL for the mobo drivers and now whenever I boot up it's looking for an ICHR10 (sp) boot disk and I have no floopy, I'm completely lost here as I've never used a floppy in BIOS except for RAID 4 years ago. How to I make it stop??

Thanks for the help