**Official ABIT IP-35 Pro Review/Overclock/Guide Thread**

[Ace-a-Rue]

...Modded bios for IP35-pro by Polygon (Rebels Haven) is updated:
-Add Performance Level for Channel A & B.
-Add Read Delay Phase adjust for Channel A & B.
-mchbar is unlocked under Win now.

I tested it by myself, work fine.

You are right, Channel0 is slots 1/3 and Channel1 is slots 2/4;
So with modded bios it's possible to change PL separately for Channel A & B .
It's better cause differents settings by defaut is frequent for this timing;
For example, if I run a hight FSB/DRAM ratio and lower frequency, I get PL 4 for channel A and PL 5 for channel B.

i installed the 17.b04.zzz modded bios...so far your 3.5 beta Memset will not work at all on vista64 SP1...it opens but i cannot uncheck "auto" and i cannot expand the page to show both channels "A" and "B".

in the bios i have PL level 8 set but it shows PL level 7.

i tried your 3.4 version of Memset and it open and allows me to uncheck "Auto" and expand the page to see both "A" & "B" channels.

i tried to make changes to PL (it says the change was made) but there is no difference when i run Everest memory bench.

EDIT:...ok, figured it out finally after reading up so more...i had to have the "Network" chipsets enabled along with "Invoke agents" also enabled...i can now adjust my PL in the bios and windows and Memset 3.5 works perfectly