Finally got my 750 FTW motherboard today, time to check a few blocks....
I had read that the EK-NF4 rev1.1 and the EK-NB/SB 6 would fit the board....lets find out....
First up was the EK-NF4 rev1.1 with an 8800 ultra with a EK-FC8800 GTX block fitted .....
There is no way to get normal barbs on the EK-NF4 rev1.1 as the block is too near the GFX block
It might have been possible if there wasn’t a component on the motherboard blocking it!
Well the EK-NF4 rev1.1 seems to be a no go with normal barbs, lets try the EK-NB/SB 6...........
The EK-NB/SB 6 sits directly under the GFX card......a big fat NO
Looks like I may have to forget about water cooling the chip and going for one of these instead
http://www.chilledpc.co.uk/shop/prod...roducts_id=490
Reply With Quote
Bookmarks