Q9450 OC / Temps / Settings

[Cob]

CPU Voltage 1.400v - I think this is a tad too high for 3.7ghz with loadline enabled. Now I know all chips are different, but I only needed 1.38v under load for 3.8ghz in my IP35 Pro.

CPU GTL Voltage Reference (0/2) 0.67 - Start at 0.63x
CPU GTL Voltage Reference (1/3) 0.67 - As above

CPU PLL Voltage 1.54v - I've a feeling you may need a tad higher, but try 1.54v to start with

FSB Termination Voltage 1.34v - Probably not far off where it should be

DRAM Voltage 1.98v - Mines set at 2.02v

NB Voltage 1.28v - Plays a huge part. Might need to go into the mid 1.30's

NB GTL Reference AUTO - Almost as important as the CPU GTL's IMO. Once you get near stable with the correct CPU GTL's this becomes the clincher. But leave on auto til you sort everything else out.

SBridge Voltage 1.20v - Fine

PCIE SATA Voltage 1.60v - Never had to move mine off 1.5v, even for 4ghz