Hi s7e9h3n,

After reading your post and see that superb results, I decided to go
directly to the nearest shop and buy the mobo Striker Extreme II and 2x1GB Super Talent Project X W2000UX2GP. So I did.

But now I am struggling even to set the memory at default values of:
2000MHz at 9-9-9-28, 1.9 V, slots 1&3.

Even if I set SLI % CPUOC and CPU AUTO the mobo does not post and beeps for ever. I have tried a lot with different variants of unlinked, sync, lower multiplier, CPU Crazy, etc., but without success.

I have also tried your settings (P1,P2 = Enable / tRRD = 5 / tRC = 4 / tRFC = 72), but again nothing.

The best that I could achieve it was to overvoltage the mobo as suggested from Anandtech (maximum recommended for sustained operation):

CPUvtt = 1.36V
Vnb = 1.6V
Vsb = 1.6V

and then to post successfully, but I get blue screen after entering VISTA32.

Did you achieve these results by tweaking mobo voltages? or not?

Could you advise me what i have to do, to reach at least the default specs
from this memory?


CPU: E8500
SEII with BIOS 704
Supertalent W2000UX2GP
2 GAINWARD 8800GTS (G92)
Watercooling system