memset is still reading my tRTP values as 2 higher than set in bios. is this a known issue w/ the software?
quick s/c @ 1200
once again, slower than my asus... but still nothing to sneeze at.
*edit*
also, i can not just set +1.4v in bios as it crashes and i have to reset cmos, however i can set +1.4v in bios if i use the special vid section. is this something w/ the board i should be worried about?
*edit edit*
ok NOW we are getting somewhere. latency is still not as low as on the asus HOWEVER ive exceeded read, write, and copy bandwidth.
apparently i left the pull ins on auto instead of enabling them to get pl7
also tweaked tREF from stock 3120T to 14592T in memset. that netted me 200 more mb read and almost 2ns less latency. now to stability test it. i expect it to pass w/ flying colors as ive done so before w/ same settings. just re-checking at this point.. 2 hours orthos ram test and im calling it a day. this dfi is getting better and better every day
Reply With Quote
Bookmarks