A short story behind Corsair Dominator @ DDR3-2462 CL9

[bachus_anonym]

isnt 2.00vPLL for auto a bit high, especially for 45nm? congrats on the MHz I appreciate the question might be straying towards off-topic, but seeing as 2.20vPLL was damanging Team Japans 65nm chips back in the day, I think its an important area to have info on, before people are inspired by your results and try it for themselves...

Cheers!

K

Damn Bachus that's some scary VPLL voltages you're running there Congrats on the speeds though

I know Good thing is, that's only for 600FSB. Up to 550FSB, it's not so bad, actually.

Did you try 790? jody reached almost the same 32m clocks as you with 888 on 790
What was the max 32m cas7?
and a question you probably wont reply to, how many boards did you try hehehe

Yep, I've seen his 15k @ 2200C8+ on C73. Very impressive! I know we did above 2000C8, but I have not pushed it too far on C73 yet.
Regarding amount of boards I tried. Honestly, only two and they are very close, within a few MHz. Those are regular retail boards with retail E8400s. As I mentioned, things seem to get a bit bumpy above 550FSB/2200DDR3 on Intel X48 boards, and a lot of voltage seems to be needed, from what I can tell, once you approach 600FSB. Plus few tweaks here and there. We're still talking on air, that is.